home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Software Vault: The Gold Collection
/
Software Vault - The Gold Collection (American Databankers) (1993).ISO
/
cdr22
/
aspi12.zip
/
README
< prev
Wrap
Text File
|
1993-04-16
|
4KB
|
92 lines
This is the release of the IN-2000 Advanced SCSI Programming
Interface (ASPI) Manager for DOS. The ASPI Manager is an
industry standard software "front end" that allows the
IN-2000 SCSI host adapter to run any ASPI compliant software
package (eg. CorelSCSI!, Central Point Utilities, Sytos Plus etc.).
Follow the instructions below for installation of the IN-2000
ASPI Manager for DOS.
Copy the file ASPIDRVR.SYS to your boot drive and add the
following line to your CONFIG.SYS file:
DEVICE=c:\path\ASPIDRVR.SYS
where c:\path\ is the drive and directory to which you copied
the ASPI driver.
Currently, there are no parameters on the "DEVICE=" line.
NOTES:
======
If you are using an IN-2000 without any hard drives attached,
the ASPI Manager will display the following message:
Always Int 13 handler not loaded
This is not a problem, since the Int 13 handler is used only to
handle disk requests for DOS. The IN-2000 BIOS may be disabled
if you are using only non-disk peripherals such as tape drives
with the ASPI Manager. The BIOS MUST be enabled to run hard
disks when using the ASPI Manager.
Up to four IN-2000 SCSI host adapter boards may be installed in
a system running the ASPI Manager. Only the one set to the
lowest BIOS address will support hard disks.
The ASPI Manager requires that an interrupt channel on the
IN-2000 be enabled. Switches 5, 6 and 7 select the interrupt
channel. Refer to the Installation Guide.
BIOS VCN:1-03 and later supports up to 7 SCSI hard drives
under DOS 5.0 and 6.0 without the need for a loadable device
driver. Switch 8 = "ON" enables multiple drive support.
See the IN-2000 Installation Guide for more information
and/or check the ALWAYS BBS (818) 597-0275 for a BIOS update.
Make certain to load any caching software (SMARTDRIVE, VCACHE,
PC-KWIK etc.) after the ASPI Manager. Most of these packages
work by hooking the disk interrupt (Int 13h), which is replaced
by the ASPI Manager.
Once the ASPI Manager is loaded DO NOT use any applications
which use the old IN-2000 SCSI Shell. Such applications
include: Always' CD-ROM driver, NovaStor's NovaBack (ver 3.56D
and earlier), IN-2000 drivers (with BIOS enabled) and Always'
supplied Sytos PLUS drivers. Both NovaBack and Sytos PLUS are
shipped with ASPI compatible tape drivers that work with the
IN-2000 ASPI Manager. A CD-ROM driver will be released in the
near future that is compatible with ASPI.
DO NOT use the IN-2000 BIOS diagnostic or low level format
functions (from DEBUG) while the ASPI Manager is loaded. To
perform diagnostics and/or to low level format a hard disk temp-
orarily remove the ASPI manager from CONFIG.SYS.
The ASPI Manager requires Hardware Revision 2.7 (An 8 pin
socketed chip) on the IN-2000 SCSI host adapter. If you do not
have this Hardware Version, contact Technical Support for
upgrades (818) 597-1400.
ASPI Supported Software and Peripherals
=======================================
Central Point 8.0 Utilities and Tape Backup with SCSI Support
Cheyenne ArcSolo DOS/NetWare Workstation Tape Backup software
CorelSCSI! Comprehensive SCSI device driver package
Sytos PLUS Tape Backup software
NovaBack DOS/NetWare Workstation Tape Backup software
Nsure DOS/Netware Workstation Tape Backup software
Network Archivist DOS/NetWare Workstation Tape Backup software
Back-IT DOS/Windows Tape Backup software
Pegasus JukeBox software
Insite Peripherals Floptical disk drive
IOMEGA OAD drivers for Bernoulli disk drives
ANY OTHER ASPI COMPLIANT SOFTWARE/HARDWARE PACKAGE